Mawloc mouth

[reitifoh]

Hey guys, a while ago I bought 2 trygon, recently I thought that using these 2 as Mawlocs would be a lot better for my army. I figured out that I have all but the fleshy lower jaw of the mawloc and was wondering if anyone has the Mawloc assembly guide, as I need to know where best to remove the trygons lower jaw so that I can replace it with the Mawlocs
All I need is the face, so if you can post it on here I would be very grateful

thanks in advance


EDIT: also I have uncovered the Haruspex's mouth pieces still on the spruce, in your opinion would this be a suitable substitute for the Mawloc Maw

[reitifoh]

Mate from my club sent me the details I needed for the conversion.

As I said I had all the parts except the fleshy jaw, so what does everyone think? does it work without it? or will I need to eventually get that small piece?

personally I think it works with AND without

[jaigo]

Looks like a big maw to me! So a job well done.

If you really want to flesh it out a bit just use greenstuff to draw some strands/webbing between the parts

[reitifoh]

Sept 4, 2015 13:50:34 GMT jaigo said:

Looks like a big maw to me! So a job well done.

If you really want to flesh it out a bit just use greenstuff to draw some strands/webbing between the parts

don't even need green stuff, got a load of modeling clay that I use for tentacles/ cosmetic appearances, when joining isn't necessary (just doesn't harden DX). the pain was removing the lower jaw, needed to literally rip it to pieces, no chance going back to trygon now (well, you only ever need 1 trygon/ prime anyway)  

[almostmercury]

The stretched flesh isn't that necessary, but I think you need some detail to change that hard edge inside the mandibles. Then I think it'll look great.